Set DAC Value

\i I A word::value

Parameter	Type	Range	Description
value	word	0 ... 1023	DAC output value

This command is used to adjust the DAC output voltage to the specified value. When the system starts up the DAC is adjustet to the value 0.

Note

The DAC has a resolution of 10 bits, resulting in a value range of decimal 0 ... 1023 (0x03FF). The decimal value 0 responds to an output voltage of 0V. The decimal value 1023 responds to an output voltage of 3.3V.
The DAC is available for DCP3090 only.
This command responds [NACK] if the "DAC Out" is not set within the "I/O Settings" tab.

Response:

[ACK]

Example

\iIA\D1023