Write Application Data to Flash

\i S A bits::flags string::filename

Parameter	Type	Range	Description
flags	bits	Bit 0, 1, 7	flags for the flash update
filename	file	DOS filename (8.3 format)	name and path of the file

This command allows to copy a raw flash file (*.rid or *.lcdp-rflash) from the MicroSD card to the internal flash memory of the iLCD Controller, whereat flags consists of the following options:

Bit	Description
0	no reboot
1	no verification
7	verbose mode

Note

Verbose mode enables the iLCD Controller to send progress information. It issues a "." character every 100kByte written and a "v" character when verifying is started.
When setting bit 0 (no reboot) in flags, the new flash data is not accessible until the iLCD Controller is rebooted. Until then, only a basic flash setup is available.
To create a raw flash file, use the "Export" feature on the "File" page of iLCD Manager XE.
The corresponding Java method for this command is writeApplicationDataToFlash() (part of the class General).

Response:

[ACK]

Example

\iSA\x1/DIR1/BACKUP_4.RID\0

This example will copy the file "BACKUP_4.RID" from the directory "DIR1" to the internal flash memory without rebooting.

Not supported by: DPC3050, DPC3020, DPC2060, DPC10xx