Set Line Ending Mode

\i A L M byte::mode

Parameter	Type	Range	Description
mode	byte	0 ... 2	mode of the line endings

Sets the line ending mode according to the following values for mode (the red dot represents the specified coordinates for the line ending resp. rectangle corner):

Mode	Single Line	Connected Lines	Description
0			line is drawn up to the last complete dash or dot
1			line is draw exactly to the specified end point
2			line is drawn to the last multiple of line thickness

• This value is only taken into account when drawing dashed or dotted lines (see Set Line Style).
• The default value for mode is 0. It will be automatically set to default on startup and by the commands Reset All or Reboot Panel Controller.

Response:

[ACK]

Example

\iALM\2

This example will set the line ending mode to mode 1 (e.g. for drawing dashed rectangles without unexpectedly cropped dashes).

Not supported by: DPC3020, DPC2060, DPC10xx

Draw Rectangle
Set Line Caps Style
Set Line Thickness
Set Line Style