Set Relays On/Off/PWM

\i I R byte::relay_no byte::mode

Parameter	Type	Range	Description
relay_no	byte	0 ... 1	number of the relay
mode	byte	0 ... 2	mode of the relay

Sets relay output relay_no to one of the following values for mode:

Mode	Description
0	set relay off
1	set relay on
2	enable PWM on relay

• Setting mode to 2 enables the PWM 0 on relay output 0 or PWM 1 on relay output 1. (see Pulse Width Modulation (PWM) Related Commands).
• By default, both relay outputs are off. This can be modified on the "Settings" page of iLCD Manager XE. It will be automatically set to default on startup and by the commands Reset All or Reboot Panel Controller.

Response:

[ACK]

Example

\iIR\0\2

Enables PWM 0 on relay output 0.

Input/Output Related Commands
Pulse Width Modulation (PWM) Related Commands
Relays One Shot