Set Smart Power-Off Mode
\i P S bool::on_off
| Parameter |
Type |
Range |
Description |
| on_off |
bool |
0 ... 1 |
determines whether smart power-off is on (1) or off (0) |
Enables or disables smart power-off functionality.
Note
- When smart power-off is on (on_off = 1), pressing the power switch does not activate the main board's power pin directly, but sends the sequence "* [ACK]" to the PC only. The PC then has to carry out the corresponding power down sequence via software.
- This sequence is also sent when the power switch is pressed and power-off notification is on (see Set Power-Off Notification On/Off).
- When smart power-off is off (on_off = 0) the power switch is directly connected to the main board's power pin.
- The default value for on_off is 0. It will be automatically set to default on startup and by the commands Reset All or Reboot Panel Controller.
Example
\iPS\1
Enables the smart power-off mode and transfers control over power management to the PC.
See also:
Power/Watchdog Related Commands
Get Power State
Copyright © demmel products gmbh. All rights reserved.