Set Filling Gradient

\i A P G byte::mode word::ramp color::from_color color::to_color

Parameter	Type	Range	Description
mode	byte	0 ... 4	gradient mode (see below)
ramp	word	0 ... max[width, height]	pixels until to_color is reached (0 = maximum)
from_color	color	0x000000 ... 0xFFFFFF	color value at beginning of gradient
to_color	color	0x000000 ... 0xFFFFFF	color value at end of gradient

Sets the active fill pattern to a gradient going from from_color to to_color. All subsequent filling will be done with a gradient dependent on mode, which can be:

Mode	from red to blue	Description
0		horizontal gradient (ramp from left)
1		vertical gradient (ramp from top)
2		horizontal symmetrical gradient (ramp from left and right)
3		vertical symmetrical gradient (ramp from top and bottom)
4		buttonized (ramp from all directions)

If ramp is set to 0 or the area to fill is smaller than ramp in the according direction, the gradient fades over the complete area disregarding the set ramp value.
In any other case, the gradient starts from from_color and gradually changes to to_color for ramp pixels. The rest of the according area is filled with the solid to_color.
The ramp is scaled by the corresponding coordinate scale factor (refer to Set Row Coordinates Scaling for horizontal and Set Column Coordinates Scaling for vertical gradients). For buttonized gradients, the smaller of those two scale factor is taken into account.
The default fill pattern is a solid color (see Set Filling Color) with a color_value of 0x000000 (black). It will be automatically set to default on startup and by the commands Reset All or Reboot Panel Controller.

Response:

[ACK]

Example

\iAPG\4\D20\#FFFFFF\#00FF00

All future filling will be done with a gradient that fades from white to blue for 20 pixels in all directions. Filling an area with this pattern will give it a three-dimensional "buttonized" look.

Not supported by: DPC3020, DPC2060, DPC10xx

Fill Display
Fill Display Area
Set Filling Color
Set Filling Tile
Draw Rectangle
Draw Styled Circle