Set Bold Mode

\i A B bool::on_off

Parameter	Type	Range	Description
on_off	bool	0 ... 1	text output is bold (1) or not (0)

Activates or deactivates bold mode for subsequent text outputs. This will add an additional pixel to the characters to be printed.

When bold mode is activated, all characters occupy one more pixel on the display in horizontal direction.
When using an anti-aliased font, bold mode is ignored.
When using the appropriate alignment functions, this is taken into account automatically, but when running the terminal mode and using cursor control ANSI sequences, this may produce unwanted results (see Terminal Mode)
There is also an ANSI escape sequence (see Syntax used in iLCD Manager XE) to enable and disable bold mode.
The default value for on_off is 0. It will be automatically set to default on startup and by the commands Reset All or Reboot Panel Controller.

Response

[ACK]

Example

\iAB\1

Causes every subsequent text to appear bold, until the command is repeated and the parameter on_off is set to 0 again.