Set Column Address

\i C C word::address

Parameter	Type	Range	Description
address	word	0 ... display width - 1	value for x coordinate

Sets the horizontal cursor position (column address).

Using this command changes the x value of the cursor position but not the y value (see Set Cursor Position).
Using values greater than the available columns causes a [NACK] to be sent.
The default value for address is 0. It will be automatically set to default on startup and by the commands Reset All or Reboot Panel Controller.

Response:

[ACK]

Example

\iCC\D25

This example sets the x value of the cursor position to 25. The y value is not affected.