Set Multiple Outputs

\i I L s word::out_mask word::blink_mask

Parameter	Type	Range	Description
out_mask	wbits	0x0000 ... 0xFFFF	every set bit represents an output turned on
blink_mask	wbits	0x0000 ... 0xFFFF	every set bit represents a blinking output

Sets multiple outputs, similar to the Set Output command.

The two masks refer to bit addressed outputs. Where bit 0 refers to output #0, bit 15 to output #15.
If pin is not previously defined as an output via iLCD Manager XE, setting this bit has no effect.
The startup values can be defined on the "Settings" page of iLCD Manager XE. All outputs will be automatically set to the startup value on startup and by the commands Reset All or Reboot Panel Controller.

Response:

[ACK]

Example

\iILs\XA\X500

This turns on outputs #1 and #3 (0xA = Bin 0000 0000 0000 1010) and sets outputs #8 and #10 (0x500 = Bin 0000 0101 0000 0000) to blink.