Set Output

\i I L S byte::out_no byte::mode

Parameter	Type	Range	Description
out_no	byte	0 ... 15	output number to be turned on/off
mode	byte	0 ... 2	mode to set

This command is used for controlling outputs via the following modes:

Multiple outputs can be controlled with the Set Multiple Outputs command.
When the output is set to blink, the frequency can be adjusted with the Set Output Blink Frequency command.
The startup values can be defined on the "Settings" page of iLCD Manager XE. All outputs will be automatically set to the startup value on startup and by the commands Reset All or Reboot Panel Controller.
When trying to address an output port that is not defined as an output via iLCD Manager XE, the command is simply ignored; a [NACK] is returned then.

Response:

[ACK]

Example

\iILS\3\2

After sending this command, output number 3 will blink (periodically toggles state after the interval specified by the blink frequency).