Set Output Blink Frequency

\i I L F byte::period

Parameter	Type	Range	Description
period	byte	1 ... 255	interval of state changes in units of 10ms

Sets the blinking frequency for all outputs by defining the interval of state changes.

When an output is currently in blink mode (see Set Output and Set Multiple Outputs), the frequency changes immediately.
The default value for period is 20, but can be modified on the "Settings" page of iLCD Manager XE. It will be automatically set to default on startup and by the commands Reset All or Reboot Panel Controller.
The pin used must first be enabled using functions or the settings tab.

Response:

[ACK]

Example

\iILF\25

This will set the blinking frequency to 2 Hertz (250ms on and 250ms off).