Set Underline Position

\i A u byte::position

Parameter	Type	Range	Description
position	signed byte	-32 ... 31	underline position

Sets the vertical position for the underline.

Underline Position is only relevant when Underline Mode is activated (see Set Underline Mode).
Setting a font (see Set Font) causes position automatically to be reset to 0.
The default value for position is 0. It will be automatically set to default on startup and by the commands Reset All or Reboot Panel Controller.
If the current vertical font spacing is 1 (see Set Font Spacing), any value greater than 0 for position causes the underline not drawn anymore as it would overwrite parts of next line.
Using a negative value for position will cause the line to be drawn within the character area (thus crossing out instead of underlining the character).
If position would cause overwriting parts of the previous line (depending on the font height), underlining is not carried out anymore.
Setting a font (see Set Font) causes position automatically to be reset to 0.

Response:

[ACK]

Example

\iAu\2

This example sets the underline position to 2 pixels below the text.